You can use the output above to obtain the disk path for this VHD and mount that into WSL following the instructions in the previous section. Write-Output "\\.\PhysicalDrive$((Mount-VHD -Path -PassThru | Get-Disk).Number)" Be sure to replace with your actual VHD path. Below is an example where we use this command, and also output the disk path. Be sure to run this command with administrator privileges. To do this, you first need to mount the VHD into Windows using the Mount-VHD command in Windows. You can also mount virtual hard disk files (VHD) into WSL using wsl -mount. WSL from the Microsoft Store introduces a new argument to directly mount a VHD: wsl -mount -vhd Once you have identified the partitions you want to mount, run this command on each partition: wsl -mount -partition -type This will output the detected filesystem type (under the TYPE="" format). If you don't know the type of filesystem of a disk or partition, you can use this command: blkid For example, /dev/sdb3, is the partition number 3 of disk sdb.Įxample output: NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT Inside Linux, a block device is identified as /dev/. This will display the available block devices and their partitions. Once attached, the partition can be listed by running the following command inside WSL 2: lsblk (In the case of our example, the is \\.\PHYSICALDRIVE*. This will make the disk available in WSL 2. List and select the partitions to mount in WSL 2 - Once the disk is identified, run: wsl -mount -bare The disks paths are listed after 'DeviceID', usually in the \\.\PHYSICALDRIVE* format. If you have a disk that you aren't sure what file format it is in, or what partitions it has, you can follow the steps below to mount it. Mount the disk - Using PowerShell, you can mount the disk using the Disk path discovered above, run: wsl -mount Usually under the \\.\PHYSICALDRIVE* format. The disks paths are available under the 'DeviceID' columns. Identify the disk - To list the available disks in Windows, run: GET-CimInstance -query "SELECT * from Win32_DiskDrive" If you have a disk that doesn't have any partitions, you can mount it directly using the wsl -mount command. In order to mount an Ext4-formatted drive on your Linux distribution with WSL, you can use the wsl -mount command following the instructions below. If you have a Ext4-formatted drive, you cannot mount it on your Windows file system. If you have mounted a NTFS-formatted drive on your Windows file system, you can access that drive from your Linux distribution using WSL by creating a mounted directory ( sudo mkdir /mnt/d, replacing 'd' with whatever drive letter you'd like to use) and then using the drvfs file system interop plugin, with the command: sudo mount -t drvfs D: /mnt/d External drives formatted for Linux typically use the Ext4 file system formatting. To check your WSL and Windows version, use the command: wsl.exe -version Differences between mounting an external drive with Windows formatting versus Linux formattingĮxternal drives formatted for Windows typically use the NTFS file system formatting. You will need to be on Windows 11 Build 22000 or later, or be running the Microsoft Store version of WSL. You can't mount the Windows installation disk. wsl -mount always attaches the entire disk even if only a partition is requested. The WSL 2 mount command does not support mounting a disk (or partitions that belong to the disk) that is currently in use. Administrator access is required to attach a disk to WSL 2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |